1gmemorymodulereset
Differences
This shows you the differences between two versions of the page.
| Next revision Both sides next revision | |||
|
1gmemorymodulereset [2008/01/27 06:21] twdorris created |
1gmemorymodulereset [2008/01/27 06:21] twdorris |
||
|---|---|---|---|
| Line 7: | Line 7: | ||
| The following describes how to perform a hard reset of the 1G memory module. | The following describes how to perform a hard reset of the 1G memory module. | ||
| - | - Turn the key on (don't start the engine) | + | - Turn the key on (don't start the engine) |
| - | - Wait for the CEL light to go back off after 5 seconds just as a check that the ECU is up and running normally. | + | - Wait for the CEL light to go back off after 5 seconds just as a check that the ECU is up and running normally. |
| - | - Press the throttle to the floor and keep it there as you cycle the ignition key off and then back on 3 or 4 times. I usually go for 4 but 3 is the minimum. | + | - Press the throttle to the floor and keep it there as you cycle the ignition key off and then back on 3 or 4 times. I usually go for 4 but 3 is the minimum. |
| Once you have done that, the ECU should reset back to the hardcoded defaults in the chip. | Once you have done that, the ECU should reset back to the hardcoded defaults in the chip. | ||
1gmemorymodulereset.txt · Last modified: 2024/03/15 11:16 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
