blownsensorground
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
blownsensorground [2009/10/20 09:50] twdorris |
blownsensorground [2009/10/20 09:51] twdorris |
||
|---|---|---|---|
| Line 19: | Line 19: | ||
| For a 1G ECU, the symptoms are the same, but the burned track can be on the top of the board connecting to ECU pin 24 or on the bottom of the board in the are beneath IC101. | For a 1G ECU, the symptoms are the same, but the burned track can be on the top of the board connecting to ECU pin 24 or on the bottom of the board in the are beneath IC101. | ||
| - | ====== Causes ====== | ||
| - | Possible causes for a blown sensor ground include powering a wideband kit (or other high-current device) off the sensor ground wire of the ECU. Another semi-common cause is a short of O2 sensor wires resting on a hot manifold! | + | |
blownsensorground.txt ยท Last modified: 2024/03/15 11:16 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
