This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
e3ecmlinkmod [2009/07/16 13:42] twdorris |
e3ecmlinkmod [2024/03/15 11:16] (current) |
||
---|---|---|---|
Line 6: | Line 6: | ||
The image below illustrates the location of this jumper and what change you need to make. | The image below illustrates the location of this jumper and what change you need to make. | ||
- | {{ http://www.ecmtuning.com/images/forums/evoecujumper.jpg }} | + | {{ https://www.ecmtuning.com/images/forums/evoecujumper.jpg }} |
To perform this move, you simply desolder the 0 ohm resistor installed at J2 and solder it into place at J1. It's easiest to do this with two soldering irons, but you can make due with 1 if you have to. | To perform this move, you simply desolder the 0 ohm resistor installed at J2 and solder it into place at J1. It's easiest to do this with two soldering irons, but you can make due with 1 if you have to. | ||
Line 17: | Line 17: | ||
**NOTE**: Your original factory EPROM should still work fine after this modification has been performed. | **NOTE**: Your original factory EPROM should still work fine after this modification has been performed. | ||
+ | |||
+ | Here's a shot after the jumper has been moved. | ||
+ | |||
+ | {{ https://www.ecmtuning.com/images/forums/evoecujumper-done.jpg }} | ||
+ |