ecuinputdata
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
ecuinputdata [2009/01/13 14:37] twdorris |
ecuinputdata [2009/02/22 09:26] dmertz |
||
|---|---|---|---|
| Line 8: | Line 8: | ||
| http://www.ecmtuning.com/product_info.php?cPath=26&products_id=39 | http://www.ecmtuning.com/product_info.php?cPath=26&products_id=39 | ||
| + | |||
| Line 16: | Line 17: | ||
| Connect "GND to ECU" to the ECU's sensor ground, pin 24 (Green/Black) on a 1G ECU or pin 92 (Black) on a 2G ECU. This is also present under the hood at the MAF, TPS, MDP and coolant temp sensors. | Connect "GND to ECU" to the ECU's sensor ground, pin 24 (Green/Black) on a 1G ECU or pin 92 (Black) on a 2G ECU. This is also present under the hood at the MAF, TPS, MDP and coolant temp sensors. | ||
| - | If the sensor is a 5V sensor that draws little current, like a MAP sensor, connect its power, signal and ground connections to the buffer circuit assembly. If the device, such as a wideband, has it's own power and ground, connect only the signal wire to the device. Insulate any unused wires. | + | If the sensor is a 5V sensor that draws little current, like a MAP sensor, connect the sensor's power, signal and ground connections to the input side of the buffer circuit assembly. If the sensing device, such as a wideband, has its own power and ground, connect only the sensing device's signal wire to the input side of the buffer. Insulate any unused wires. |
ecuinputdata.txt ยท Last modified: 2024/03/15 11:16 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
