This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
ethadapter1g [2014/05/21 13:32] twdorris created |
ethadapter1g [2024/03/15 11:16] (current) |
||
---|---|---|---|
Line 5: | Line 5: | ||
- | The adapter we provide to connect an ethanol sensor directly to our SD cable has two free pins that need to be installed into the MAF connector end of the SD cable. For a 1G-style MAF connector, you must first remove the orange locking tab. This is done by simply prying on the small hole in the locking tab using the connector housing as your leverage point. Then you simply push the pins (and seals) into place and reinstall the locking tab. | + | The adapter we provide to connect an ethanol sensor directly to our SD cable has two free pins that need to be installed into the MAF connector end of the SD cable. For a 1G-style MAF connector, you must first remove the orange locking tab. This is done by simply prying on the small hole in the locking tab using the connector housing as your leverage point. Then you simply push the pins (and seals) into place and reinstall the locking tab. |
- | | {{:ethanolsensor:eth2g-pin-insert.png?direct&161x200}} | {{:ethanolsensor:eth2g-pin-done.png?nolink&118x200}} | | + | | {{:ethanolsensor:eth1g-lockingtab.png?direct&254x200}} | {{:ethanolsensor:eth1g-pin-insert.png?direct&108x200}} | {{:ethanolsensor:eth1g-pin-done.png?direct&89x200}} | |
- | | **(click to enlarge)** | **(click to enlarge)** | | + | | | **(click to enlarge)** | **(click to enlarge)** | |
Line 18: | Line 18: | ||
* Pink/Gray | * Pink/Gray | ||
* Yellow/Black | * Yellow/Black | ||
+ | |||
+ | |||
+ | Note that cables manufactured after 8/8/2016 use a violet wire in place of the previously used pink wire. So one additional possible combination is: | ||
+ | |||
+ | |||
+ | * Violet/Gray | ||
Line 28: | Line 34: | ||
If you have a yellow/black adapter, just use the yellow wire in place of red and use the black in place of white. | If you have a yellow/black adapter, just use the yellow wire in place of red and use the black in place of white. | ||
+ | |||
+ | \\ | ||
===== Ground wire ===== | ===== Ground wire ===== |