This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
ethadapter2g [2014/05/21 13:27] twdorris |
ethadapter2g [2024/03/15 11:16] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Ethanol Sensor to 2G/EVO1-3 SD Cable Adapter ====== | ====== Ethanol Sensor to 2G/EVO1-3 SD Cable Adapter ====== | ||
+ | |||
+ | |||
+ | ===== MAF connector wires ===== | ||
Line 5: | Line 8: | ||
- | | {{:ethanolsensor:eth2g-pin-insert.png?direct&161x200}} | {{:ethanolsensor:eth2g-pin-done.png?nolink&118x200}} | | + | | {{:ethanolsensor:eth2g-pin-insert.png?direct&161x200}} | {{:ethanolsensor:eth2g-pin-done.png?direct&118x200}} | |
| **(click to enlarge)** | **(click to enlarge)** | | | **(click to enlarge)** | **(click to enlarge)** | | ||
Line 12: | Line 15: | ||
- | * Red/White | + | * White/Red |
- | * Pink/Gray | + | * Gray/Pink (or Gray/Violet) |
- | * Yellow/Black | + | * Black/Yellow |
+ | |||
+ | |||
+ | Note that cables manufactured after 8/8/2016 use a violet wire in place of the previously used pink wire. So one additional possible combination is: | ||
+ | |||
+ | |||
+ | * Gray/Violet | ||
Line 23: | Line 32: | ||
- | If you have a yellow/back adapter, just use the yellow wire in place of red and use the black in place of white. | + | If you have a yellow/black adapter, just use the yellow wire in place of red and use the black in place of white. |
+ | |||
+ | |||
+ | \\ | ||
+ | |||
+ | ===== Ground wire ===== | ||
+ | |||
+ | |||
+ | The black wire with ring terminal coming off the ethanol connector needs to go to a good, **clean** chassis ground point. | ||
\\ | \\ | ||