ethadapter2g
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
ethadapter2g [2014/05/21 13:23] twdorris created |
ethadapter2g [2024/03/15 11:16] (current) |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| - | The adapter we provide to connect an ethanol sensor directly to our SD cable has two free pins that need to be installed into the MAF connector end of the SD cable. For a 2G-style MAF connector, this process is pretty simple. You simply push the pins (and seals) into place. | + | ===== MAF connector wires ===== |
| - | The only possible source of confusion I can foresee would be the wire colors. To reduce our cost, we're splitting out a 6-conductor ribbon cable (the same one used to produce our GM MAF cables) to make three different 2-conductor cables for use in this adapter. So you may have an adapter with any one of these three different color combinations. | + | The adapter we provide to connect an ethanol sensor directly to our SD cable has two free pins that need to be installed into the MAF connector end of the SD cable. For a 2G-style MAF connector, this process is pretty simple. You simply push the pins (and seals) into place. |
| - | * Red/White | + | | {{:ethanolsensor:eth2g-pin-insert.png?direct&161x200}} | {{:ethanolsensor:eth2g-pin-done.png?direct&118x200}} | |
| - | * Pink/Gray | + | | **(click to enlarge)** | **(click to enlarge)** | |
| - | * Yellow/Black | + | |
| + | |||
| + | To reduce cost, we split out a 6-conductor ribbon cable to make three different 2-conductor cables for use in this adapter. So you may have an adapter with any one of these three different color combinations. | ||
| + | |||
| + | |||
| + | * White/Red | ||
| + | * Gray/Pink (or Gray/Violet) | ||
| + | * Black/Yellow | ||
| + | |||
| + | |||
| + | Note that cables manufactured after 8/8/2016 use a violet wire in place of the previously used pink wire. So one additional possible combination is: | ||
| + | |||
| + | |||
| + | * Gray/Violet | ||
| Line 19: | Line 32: | ||
| - | <font 13px/arial;;#000000;;#ffffff>If you have a yellow/back adapter, just use the yellow wire in place of red and use the black in place of white.</font> | + | If you have a yellow/black adapter, just use the yellow wire in place of red and use the black in place of white. |
| + | |||
| + | |||
| + | \\ | ||
| + | |||
| + | ===== Ground wire ===== | ||
| + | |||
| + | |||
| + | The black wire with ring terminal coming off the ethanol connector needs to go to a good, **clean** chassis ground point. | ||
| + | |||
| + | |||
| + | \\ | ||
ethadapter2g.1400692987.txt.gz · Last modified: 2014/05/21 13:23 by twdorris
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
