This shows you the differences between two versions of the page.
externalsensorinstall [2008/01/23 07:23] 76.100.119.159 |
externalsensorinstall [2024/03/15 11:16] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Installation ====== | ||
- | |||
- | The basic process for installing an external (aftermarket) sensor for datalogging use with DSMLink is pretty simple. The details can get a little time consuming and tedious. But the general idea is to do the following. | ||
- | |||
- | - Install new device/sensor into vehicle per manufacturers instructions. | ||
- | - Locate/determine device/sensors analog output wire. | ||
- | - Choose an available [[ExternalSensorInput|ECU input]] to which you will connect the sensor's output. See the [[ECUWiringInformation|ECU wiring page]] for information on ECU connector pin numbers. | ||
- | - Connect the analog output wire to chosen ECU input. | ||
- | - In the DSMLink application add the new item to captured values list. | ||
- | |||
- | The following diagram, while specific to a Zeitronix WBO2 install on a 1G, is still useful in illustrating the general idea. It shows the Zeitronix kit (external sensor) and how the various types of connections are made to the ECU wiring and then a general description of how to proceed after that. | ||
- | |||
- | CLICK TO ENLARGE: | ||
- | |||
- | [[http://www.dsmlink.com/images/forums/Zeitronix.jpg|{{http://www.dsmlink.com/images/forums/Zeitronix.jpg?519x352}}]] | ||