This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
gm3barinstall [2008/08/05 09:42] twdorris |
gm3barinstall [2008/08/05 09:43] twdorris |
||
---|---|---|---|
Line 47: | Line 47: | ||
If you want to solder, that is best, but I just used vampire taps. Tap the connector into the appropriate lines. | If you want to solder, that is best, but I just used vampire taps. Tap the connector into the appropriate lines. | ||
- | |||
- | |||
That's about it. Hook up the vac lines. Use a zip tie around each connection. | That's about it. Hook up the vac lines. Use a zip tie around each connection. | ||
Line 54: | Line 52: | ||
Tape up your wires with electrical tape, and secure your map sensor somewhere safe. | Tape up your wires with electrical tape, and secure your map sensor somewhere safe. | ||
- | + | {{http://www.ecmtuning.com/images/forums/gm3barinstall/newmap_installed.jpg?160x120|Click to enlarge}} |