This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
howto [2008/01/23 06:59] 76.100.119.159 |
howto [2010/05/18 13:12] turbosax2 |
||
---|---|---|---|
Line 4: | Line 4: | ||
===== Hardware ===== | ===== Hardware ===== | ||
- | * [[SwapPlugWires|Installing DSMLink in a car without a '95/'96 style cam angle sensor]] | + | * [[SwapPlugWires|2G plug wire swap]] - Installing DSMLink in a car without a '95/'96 style cam angle sensor |
- | * [[90ClutchCut|Installing a clutch cut (NLTS) wire in a 1990 DSM]] | + | * [[90ClutchCut|Clutch cut wire on a '90 DSM]] - Installing a clutch cut (NLTS) wire in a 1990 DSM |
- | * [[NitrousControlDetails]] | + | * [[NitrousControlWiring|Basic "nitrous" controls]] - The basics of wiring up a solenoid to be control by DSMLink's "nitrous" controls |
- | * [[NitrousControlWiring]] | + | * [[NitrousControlDetails|"Nitrous" control specifics]] - More specific information about DSMLink's control of the FPR solenoid output |
- | * [[UseNitrousControlsForDejonToolBOVMod]] | + | * [[UseNitrousControlsForDejonToolBOVMod|"Nitrous" control used for BOV bypass mod]] - Describes one alternative use of DSMLink's "nitrous" controls |
* [[InstallNewSensor|Install a sensor for datalogging]] - Describes how to use a non-factory sensor for datalogging (e.g., a boost sensor, a wideband kit, etc.) | * [[InstallNewSensor|Install a sensor for datalogging]] - Describes how to use a non-factory sensor for datalogging (e.g., a boost sensor, a wideband kit, etc.) | ||
+ | |||
===== Tuning/dial-in ===== | ===== Tuning/dial-in ===== | ||
- | * [[MAFTCalibrationByWBO2]] | + | * [[BasicFuelAdj|Changing injectors]] - Describes how to adjust DSMLink for different injectors |
- | * [[MAFTCalibrationByLoggedBoost]] | + | * [[v3mafadjcombft|General MAF calibration]] - How-to on general MAF calibration with the V3 application |
- | * [[CreateVolumetricEfficiencyMap]] | + | * [[MAFTCalibrationByWBO2|MAFT Calibration using a WBO2]] - Describes how to calibrate a MAFT output using a WBO2 |
- | * [[2GTimingIn1GECU]] | + | * [[MAFTCalibrationByLoggedBoost|MAFT Calibration using a boost sensor]] - Describes how to calibrate a MAFT output using a boost sensor |
- | * [[DSMLinkTPSAdjustment]] | + | * [[CreateVolumetricEfficiencyMap|Customize the VE table for your setup]] - Create a VE table more suited to your specific setup |
- | + | * [[v3tpsadj|How to dial in TPS/idle switch]] | |
- | ===== Alternate OS'es ===== | + | |
- | + | ||
- | * LinuxInstall | + | |
- | * MacOSInstall | + | |
- | * PocketPCInstall | + | |
+ | ===== Direct Access ===== | ||
+ | * [[Direct Access changes]] - Describes how to add custom changes to Direct Access |