This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
howto [2008/01/23 09:24] 76.100.119.159 |
howto [2010/05/18 13:12] turbosax2 |
||
---|---|---|---|
Line 10: | Line 10: | ||
* [[UseNitrousControlsForDejonToolBOVMod|"Nitrous" control used for BOV bypass mod]] - Describes one alternative use of DSMLink's "nitrous" controls | * [[UseNitrousControlsForDejonToolBOVMod|"Nitrous" control used for BOV bypass mod]] - Describes one alternative use of DSMLink's "nitrous" controls | ||
* [[InstallNewSensor|Install a sensor for datalogging]] - Describes how to use a non-factory sensor for datalogging (e.g., a boost sensor, a wideband kit, etc.) | * [[InstallNewSensor|Install a sensor for datalogging]] - Describes how to use a non-factory sensor for datalogging (e.g., a boost sensor, a wideband kit, etc.) | ||
+ | |||
===== Tuning/dial-in ===== | ===== Tuning/dial-in ===== | ||
+ | * [[BasicFuelAdj|Changing injectors]] - Describes how to adjust DSMLink for different injectors | ||
+ | * [[v3mafadjcombft|General MAF calibration]] - How-to on general MAF calibration with the V3 application | ||
* [[MAFTCalibrationByWBO2|MAFT Calibration using a WBO2]] - Describes how to calibrate a MAFT output using a WBO2 | * [[MAFTCalibrationByWBO2|MAFT Calibration using a WBO2]] - Describes how to calibrate a MAFT output using a WBO2 | ||
* [[MAFTCalibrationByLoggedBoost|MAFT Calibration using a boost sensor]] - Describes how to calibrate a MAFT output using a boost sensor | * [[MAFTCalibrationByLoggedBoost|MAFT Calibration using a boost sensor]] - Describes how to calibrate a MAFT output using a boost sensor | ||
* [[CreateVolumetricEfficiencyMap|Customize the VE table for your setup]] - Create a VE table more suited to your specific setup | * [[CreateVolumetricEfficiencyMap|Customize the VE table for your setup]] - Create a VE table more suited to your specific setup | ||
- | * [[2GTimingIn1GECU|Settings to run 2G timing in a 1G]] | + | * [[v3tpsadj|How to dial in TPS/idle switch]] |
- | * [[DSMLinkTPSAdjustment|How to dial in TPS/idle switch]] | + | |
- | + | ||
- | ===== Alternate OS'es ===== | + | |
- | + | ||
- | * [[LinuxInstall|Linux install]] | + | |
- | * [[MacOSInstall|MacOS install]] | + | |
- | * [[PocketPCInstall|PocketPC install]] | + | |
- | * [[PalmInstall|Palm install]] | + | |
+ | ===== Direct Access ===== | ||
+ | * [[Direct Access changes]] - Describes how to add custom changes to Direct Access |