User Tools

Site Tools


howto

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

howto [2010/05/18 13:12]
turbosax2
howto [2024/03/15 11:16]
Line 1: Line 1:
-====== How-To'​s ====== 
-This page is a collection of how-to'​s from those that have-done.  ​ 
  
-===== Hardware ===== 
- 
-  * [[SwapPlugWires|2G plug wire swap]] - Installing DSMLink in a car without a '​95/'​96 style cam angle sensor 
-  * [[90ClutchCut|Clutch cut wire on a '90 DSM]] - Installing a clutch cut (NLTS) wire in a 1990 DSM 
-  * [[NitrousControlWiring|Basic "​nitrous"​ controls]] - The basics of wiring up a solenoid to be control by DSMLink'​s "​nitrous"​ controls 
-  * [[NitrousControlDetails|"​Nitrous"​ control specifics]] - More specific information about DSMLink'​s control of the FPR solenoid output 
-  * [[UseNitrousControlsForDejonToolBOVMod|"​Nitrous"​ control used for BOV bypass mod]] - Describes one alternative use of DSMLink'​s "​nitrous"​ controls 
-  * [[InstallNewSensor|Install a sensor for datalogging]] - Describes how to use a non-factory sensor for datalogging (e.g., a boost sensor, a wideband kit, etc.) 
- 
- 
-===== Tuning/​dial-in ===== 
- 
-  * [[BasicFuelAdj|Changing injectors]] - Describes how to adjust DSMLink for different injectors 
-  * [[v3mafadjcombft|General MAF calibration]] - How-to on general MAF calibration with the V3 application 
-  * [[MAFTCalibrationByWBO2|MAFT Calibration using a WBO2]] - Describes how to calibrate a MAFT output using a WBO2 
-  * [[MAFTCalibrationByLoggedBoost|MAFT Calibration using a boost sensor]] - Describes how to calibrate a MAFT output using a boost sensor 
-  * [[CreateVolumetricEfficiencyMap|Customize the VE table for your setup]] - Create a VE table more suited to your specific setup 
-  * [[v3tpsadj|How to dial in TPS/idle switch]] 
- 
- 
-===== Direct Access ===== 
-  * [[Direct Access changes]] - Describes how to add custom changes to Direct Access 
howto.txt ยท Last modified: 2024/03/15 11:16 (external edit)