hptorque
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
hptorque [2008/01/30 08:16] twdorris |
hptorque [2011/03/23 14:40] twdorris removed |
||
|---|---|---|---|
| Line 9: | Line 9: | ||
| The calculation of HP/torque is done by watching RPM acceleration and factoring in drag based on wheel speed. The routine also uses information provided by the user on wheel size and drivetrain loss. You configure those values by right clicking on either HP or Torque in the graph legend and then selecting "Props". | The calculation of HP/torque is done by watching RPM acceleration and factoring in drag based on wheel speed. The routine also uses information provided by the user on wheel size and drivetrain loss. You configure those values by right clicking on either HP or Torque in the graph legend and then selecting "Props". | ||
| + | ====== Examples ====== | ||
| + | The following was posted by one of our users as an example of what he saw as a comparison between the HP/Torque estimates in DSMLink and an actual dyno pull. Not too shabby. | ||
| + | |||
| + | **Click to enlarge** | ||
| + | |||
| + | {{dynosnap1lp1.jpg?341x246|Dyno comparison}} | ||
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
