This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
The following has been copied from the DSMLink forums. The original (courtesy of Ron Francis) may be found at in this user support forum thread (registered DSMLink users only). The text below has been updated to include 1g-specific info, as well as other minor edits.
These instructions are for those without a WBO2 who are logging an external boost source. This method tends to produce much more accurate airflow readings. Although tuning by WBO2 works, this method is superior. You can use any accurate external boost source that DSMLink supports with this method. Happy Tuning!
Example: If LTFT-Lo is at a constant +5%, add +5% to the 50 Hz slider in the airflow table. If the LTFT-Lo is at a constant +12.5% and STFT is at +13%, add +26% to the 50 Hz slider in the airflow table. Repeat until you are happy.
Example: If STFT’s are bouncing between +14% and +16%, add +15% to the 150 Hz slider in the airflow table. Repeat until you are happy.
Example: If the fuel trim is at a constant +7%, add +7% to the 250 Hz slider in the airflow table. Repeat until you are happy.