nitrouscontrolwiring
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
nitrouscontrolwiring [2008/12/23 06:47] twdorris |
nitrouscontrolwiring [2009/08/11 05:54] twdorris |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== "Nitrous" Control Wiring ====== | ====== "Nitrous" Control Wiring ====== | ||
| - | ECMLink nitrous controls provide a means of defining parameters that activate the fuel pressure regulator solenoid output on the ECU. This output is a switch to ground. That is to say when active, that ECU pin will be connected to ground. When not active, it floats. But that ground connection is *not* sufficient to directly drive a high pressure solenoid. You must use a relay and, preferably, a master arm switch between the ECU and the solenoids being driven if you're using large solenoids. Trying to drive the solenoid(s) directly from the ECU **will** result in damage to the ECU. | + | ECMLink's output controls provide a means of defining parameters that activate any one of a few solenoid outputs on the ECU. These outputs are all switches to ground. That is to say when active, that ECU pin will be connected to ground. When not active, it floats. But that ground connection is *not* sufficient to directly drive a high pressure solenoid. You must use a relay and, preferably, a master arm switch between the ECU and the solenoids being driven if you're using large solenoids. Trying to drive the solenoid(s) directly from the ECU **will** result in damage to the ECU. |
| - | Also, nitrous controls are by no means used solely for controlling nitrous kits. That was the original intention, but our users have been far more clever in how they use this feature in ECMLink. They have used it to control water injection, methanol, [[UseNitrousControlsForDejonToolBOVMod|blow off valve bypass]], and probably a few other things we're not even aware of. So this page is going to describe the general approach to using the FPR solenoid output of the ECU to drive a larger solenoid through a relay. The rest is going to be up to you and your particular situation. | + | ECMLink's output controls can be used for a variety of things. Our users have been far more clever in how they use this feature than we ever imagined. They have used it to control water injection, methanol, [[UseNitrousControlsForDejonToolBOVMod|blow off valve bypass]], and probably a few other things we're not even aware of. So this page is going to describe the general approach to using solenoid outputs of the ECU to drive a larger solenoid through a relay. The rest is going to be up to you and your particular situation. |
| - | Details on the internal functionality of the ECMLink Nitrous Controls can be found on the [[NitrousControlDetails|nitrous control details]] page. | + | Details on the internal functionality of ECMLink's output controls can be found on the [[NitrousControlDetails|nitrous control details]] page. |
| ====== Details ====== | ====== Details ====== | ||
nitrouscontrolwiring.txt ยท Last modified: 2024/03/15 11:16 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
