nitrouscontrolwiring
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
nitrouscontrolwiring [2009/08/11 05:54] twdorris |
nitrouscontrolwiring [2009/08/11 05:55] twdorris |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== "Nitrous" Control Wiring ====== | + | ====== ECMLink's Output Control Wiring (formerly known as "Nitrous" Controls) ====== |
| ECMLink's output controls provide a means of defining parameters that activate any one of a few solenoid outputs on the ECU. These outputs are all switches to ground. That is to say when active, that ECU pin will be connected to ground. When not active, it floats. But that ground connection is *not* sufficient to directly drive a high pressure solenoid. You must use a relay and, preferably, a master arm switch between the ECU and the solenoids being driven if you're using large solenoids. Trying to drive the solenoid(s) directly from the ECU **will** result in damage to the ECU. | ECMLink's output controls provide a means of defining parameters that activate any one of a few solenoid outputs on the ECU. These outputs are all switches to ground. That is to say when active, that ECU pin will be connected to ground. When not active, it floats. But that ground connection is *not* sufficient to directly drive a high pressure solenoid. You must use a relay and, preferably, a master arm switch between the ECU and the solenoids being driven if you're using large solenoids. Trying to drive the solenoid(s) directly from the ECU **will** result in damage to the ECU. | ||
nitrouscontrolwiring.txt ยท Last modified: 2024/03/15 11:16 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
