Differences

This shows you the differences between two versions of the page.

--- sdcabledecision [2011/03/18 06:52]
twdorris created
+++ sdcabledecision [2011/05/09 09:32]
twdorris
@@ Line 10: / Line 10: @@
 But if you already have the car running well on the MAF sensor, it's nice to be able to auto-dial in the VE table using our [[sdveadjsdratio|SD VE Adjust]] procedure.  Read through that page for more details, but the basic idea is to let the laptop application calculate your VE table for you as you drive around on a well calibrated MAF setup.  Then, when you remove the MAF and switch to SD, you have a really good starting point for your engine already setup and ready to go.
-The problem is that you have to be able to run on the MAF sensor while simultaneously datalogging the MAP signal in order to use this tool.  And if you plan to run out SD cable, you can't exactly do that because the SD cable replaces the MAF sensor.
+The problem is that you have to be able to run on the MAF sensor while simultaneously datalogging the MAP signal in order to use this tool.  And if you plan to run our SD cable, you can't exactly do that because the SD cable replaces the MAF sensor.
 So there are a couple options to consider.  Neither of which is perfect.

ECMTuning - wiki