This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
sdoptions [2016/07/05 15:14] twdorris [Speed Density Options and Configurations] |
sdoptions [2016/07/31 08:07] twdorris [IAT Sensor or Not] |
||
---|---|---|---|
Line 13: | Line 13: | ||
- | The simplest choice to make is whether you want to run an IAT sensor or not. Many people run without an IAT sensor at all simply because they either don't want to install one or they actually want the mixture to run a little richer as air temps increase or they want to use the IAT input to log something else. | + | The simplest choice to make is whether you want to run an IAT sensor or not. Here are a few reasons you might want to run speed density without an IAT sensor. |
+ | |||
+ | |||
+ | * You don't want to install the IAT bung on the throttle body elbow or you just run temporarily without an IAT sensor and then install one later. | ||
+ | * You want to use the IAT input to log something else. | ||
+ | * You want to use the MAF for a while as you dial in the SD table using our [[:sdveadjsdratio|MAF/SD VE Table Tool]]. | ||