User Tools

Site Tools


sdoptions

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
sdoptions [2016/07/31 08:05]
twdorris [IAT Sensor or Not]
sdoptions [2017/08/13 10:56]
twdorris [Other considerations not covered]
Line 18: Line 18:
   * You don't want to install the IAT bung on the throttle body elbow or you just run temporarily without an IAT sensor and then install one later.   * You don't want to install the IAT bung on the throttle body elbow or you just run temporarily without an IAT sensor and then install one later.
   * You want to use the IAT input to log something else.   * You want to use the IAT input to log something else.
-  * You want to use the MAF for a while as you dial in the SD table using our MAF-to-SDVE tool ([[:​sdveadjsdratio|:​sdveadjsdratio]])+  * You want to use the MAF for a while as you dial in the SD table using our [[:​sdveadjsdratio|MAF/SD VE Table Tool]]
 +  * You want to use the Mitsu-style MAP sensor bolted to your intake manifold and don't want to wire in an IAT sensor separately.
  
  
Line 38: Line 39:
  
  
-For example, you could already have a MAP sensor and just want to install the IAT sensor. In this case, you might want to hard wire it or use the SD Cable anyway.+For example, you could already have a MAP sensor and just want to install the IAT sensor. In this case, you might want to hard wire it or use the SD Cable anyway ​and just leave the MAP connector end of the SD cable unused (or cut off and wired to log something else).
  
  
sdoptions.txt · Last modified: 2024/03/15 11:16 (external edit)