sdoptions
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
sdoptions [2016/07/05 14:41] twdorris [IAT Sensor or Not] |
sdoptions [2024/03/15 11:16] (current) |
||
|---|---|---|---|
| Line 5: | Line 5: | ||
| - | First, pricing information is listed on our website. So that one's easy. | + | First, pricing information is listed on our website. So that one's easy once you've decided which items to order. |
| - | But to figure out what to order, you have to consider a number of different configuration options. This page attempts to list these out in a "walk-through" layout. | + | But to figure out what to order, you have to consider a number of different configuration options. This page attempts to list these out in a "walk-through" type layout. |
| ===== IAT Sensor or Not ===== | ===== IAT Sensor or Not ===== | ||
| - | The simplest choice to make is whether you want to run an IAT sensor or not. Many people run without an IAT sensor at all simply because they either don't want to install one or they actually want the mixture to run a little richer as air temps increase or they want to use the IAT input to log something else. | + | The simplest choice to make is whether you want to run an IAT sensor or not. Here are a few reasons you might want to run speed density without an IAT sensor. |
| + | |||
| + | |||
| + | * You don't want to install the IAT bung on the throttle body elbow or you just run temporarily without an IAT sensor and then install one later. | ||
| + | * You want to use the IAT input to log something else. | ||
| + | * You want to use the MAF for a while as you dial in the SD table using our [[:sdveadjsdratio|MAF/SD VE Table Tool]]. | ||
| + | * You want to use the Mitsu-style MAP sensor bolted to your intake manifold and don't want to wire in an IAT sensor separately. | ||
| Line 34: | Line 39: | ||
| - | For example, you could already have a MAP sensor and just want to install the IAT sensor. In this case, you might want to hard wire it or use the SD Cable anyway. | + | For example, you could already have a MAP sensor and just want to install the IAT sensor. In this case, you might want to hard wire it or use the SD Cable anyway and just leave the MAP connector end of the SD cable unused (or cut off and wired to log something else). |
sdoptions.1467744096.txt.gz · Last modified: 2016/07/05 14:41 by twdorris
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
