This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
sdoptions_iat [2016/07/05 14:37] twdorris [GM-style MAP with IAT] |
sdoptions_iat [2016/07/05 14:42] twdorris [SD Options - With IAT sensor] |
||
---|---|---|---|
Line 8: | Line 8: | ||
- | <font 12.8px/arial;;#000000;;#ffffff>Also make sure the</font> IAT<font 12.8px/arial;;#000000;;#ffffff>bung is installed properly. Because it's a tapered thread, it can be installed upside down! You want the tapered end of the threads to be installed towards the inside of the piping. There's a beveled edge to the side where you'll install the IAT sensor itself.</font> | + | Also make sure the IAT bung is installed properly. Because it's a tapered thread, it can be installed upside down! You want the tapered end of the threads to be installed towards the inside of the piping. There's a beveled edge to the side where you'll install the IAT sensor itself. |
===== GM-style MAP with IAT ===== | ===== GM-style MAP with IAT ===== | ||
Line 21: | Line 21: | ||
For the IAT sensor, you want one side going to sensor ground and the other side going to the ECU's IAT input. | For the IAT sensor, you want one side going to sensor ground and the other side going to the ECU's IAT input. | ||
- | ==== Mitsubishi-style MAP with IAT ==== | + | ===== Mitsubishi-style MAP with IAT ===== |