This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
We get asked fairly often about the actual socket we use when doing a socket job on an ECU. This page is just a collection of that information.
We use a low-profile, machined-pin socket made by Mill-Max. It's a 28-pin socket, of course, to match the 28-pin EPROM used in the DSM _ckgedit_QUOTckgedit_QUOT_ECUs_ckgedit_QUOTckgedit_QUOT_.
To order one of these, you can just contact Digi-Key using the part number information above. A picture of this socket is provided below.