User Tools

Site Tools


usenitrouscontrolsfordejontoolbovmod

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
usenitrouscontrolsfordejontoolbovmod [2008/01/24 07:46]
twdorris
usenitrouscontrolsfordejontoolbovmod [2024/03/15 11:16] (current)
Line 7: Line 7:
 I used the nitrous controls in DSMLink to control the fuel pressure solenoid. Basically, you feed a pre-throttle plate pressure source ("​A"​ port on a 2G TB or the "​A1"​ port on a 1G) into the "​input"​ side of the fuel pressure solenoid. Then feed the switched output to the bottom feed of the 1G BOV. Using the standard nitrous controls in DSMLink you can then have the BOV completely shut with high throttle, but completely stock at all other times. ​ The picture below illustrates which port on the fuel pressure solenoid goes where. I used the nitrous controls in DSMLink to control the fuel pressure solenoid. Basically, you feed a pre-throttle plate pressure source ("​A"​ port on a 2G TB or the "​A1"​ port on a 1G) into the "​input"​ side of the fuel pressure solenoid. Then feed the switched output to the bottom feed of the 1G BOV. Using the standard nitrous controls in DSMLink you can then have the BOV completely shut with high throttle, but completely stock at all other times. ​ The picture below illustrates which port on the fuel pressure solenoid goes where.
  
-{{http://www.dsmlink.com/​images/​forums/​bovfps.jpg}}+{{https://www.ecmtuning.com/​images/​forums/​bovfps.jpg}}
  
 If you're going to run more than, say, 20-21 psi with this mod, and you plan to do more than drag race, then you'll need to pay a little more attention to the throttle activation point. In my case, I wanted to run the car at the road course with spikes to 23psi, holding a pretty constant 21psi after that. The problem is that the 1G BOV will open on its own around 19psi. I couldn'​t just plug in a really high TPS value into the nitrous controls because there were plenty of times I was modulating the throttle below that point but still building more than 19psi. Just using a high TPS value resulted in the BOV opening at odd times, defeating the purpose of the mod. If you're going to run more than, say, 20-21 psi with this mod, and you plan to do more than drag race, then you'll need to pay a little more attention to the throttle activation point. In my case, I wanted to run the car at the road course with spikes to 23psi, holding a pretty constant 21psi after that. The problem is that the 1G BOV will open on its own around 19psi. I couldn'​t just plug in a really high TPS value into the nitrous controls because there were plenty of times I was modulating the throttle below that point but still building more than 19psi. Just using a high TPS value resulted in the BOV opening at odd times, defeating the purpose of the mod.
usenitrouscontrolsfordejontoolbovmod.1201178802.txt.gz ยท Last modified: 2008/01/24 07:46 by twdorris