ECMTuning - wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

<h1>Using a 1G non-turbo (NT) EPROM ECU</h1> <div class="level1"> <p> Turbo model 1G EPROM ECUs are getting harder and harder to find. So people have started asking about running a non-turbo ECU in their turbo cars. Although it's technically possible to start and basically run a 1G turbo DSM using an unmodified 2.0L non-turbo 1G ECU, there are a number of reasons why this is undesirable. </p> <p> The most obvious problem is that the non-turbo ECU does not include support for the knock sensor. Which means you get zero help from the ECU when the engine starts to knock. In addition, the non-turbo ECU lacks support for the boost gauge, 4 solenoid drivers, and the MAF reset signal. The ECU also needs to have the RC network modified on the injector outputs. </p> <p> A non-turbo 2.0L 1G EPROM ECU can, however, be modified to run properly in a 1G turbo model car. But this requires a good bit of work and time investment and as such, isn't exactly cheap. If you have a free or pretty cheap EPROM model non-turbo ECU on your hands already and you really need a turbo model EPROM ECU, then this might be a reasonable approach to take. Otherwise, it may be better to just keep trying to locate a turbo model ECU. </p> <p> Please note that this is all very specific to the 2.0L non-turbo ECU. The 1.8L non-turbo ECU only has one ignition output meant to drive a single coil and distributor and as such is not compatible with the 2.0L turbo model DSM at all. </p> </div>