This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
v3configs [2009/12/23 08:13] twdorris |
v3configs [2009/12/23 08:13] twdorris |
||
---|---|---|---|
Line 43: | Line 43: | ||
If you *only* want data from one table without everything else on that same tab, then right click in the table and select "copy table". That places a copy of that table data into the clipboard. Now, connect to your ECU and pull up the ECU Config tab where that table is located, right click again and select "paste table". | If you *only* want data from one table without everything else on that same tab, then right click in the table and select "copy table". That places a copy of that table data into the clipboard. Now, connect to your ECU and pull up the ECU Config tab where that table is located, right click again and select "paste table". | ||
+ | |||
Line 54: | Line 55: | ||
Information on changes included in each release can be found our [[v3firmwarechangelog|V3 Firmware Changelog page]]. | Information on changes included in each release can be found our [[v3firmwarechangelog|V3 Firmware Changelog page]]. | ||
+ | |||
**DIRECT ACCESS NOTE:** Direct Access data already has a "reset to stock" function built-in because "stock" in that case is very clear. But ECU Config "stock" data is not so clear and may have slightly different values with each release. The files below provide "stock" ECU Config data files for each release. They do not contain any direct access data. | **DIRECT ACCESS NOTE:** Direct Access data already has a "reset to stock" function built-in because "stock" in that case is very clear. But ECU Config "stock" data is not so clear and may have slightly different values with each release. The files below provide "stock" ECU Config data files for each release. They do not contain any direct access data. | ||