User Tools

Site Tools


v3hardreset

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Last revision Both sides next revision
v3hardreset [2009/05/26 16:10]
dmertz
v3hardreset [2009/05/26 16:11]
dmertz
Line 12: Line 12:
 Additional notes: Additional notes:
  
- - The vehicle speed must be zero. +  ​- The vehicle speed must be zero. 
- - ThrotPos must exceed 72%.  (Verify by logging.) +  - ThrotPos must exceed 72%.  (Verify by logging.) 
- - Beginning with the ignition on but the engine not running, the minimum sequence is:  turn the key off (first time) for 1/2 second, on for 1/2 second, off (second time) for 1/2 second, on for 1/2 second, off (third time) for 1/2 second, then on and leave on. (The speed of the off-on should be about like a clock going tick-tock or a bit faster. ​ Failure to reset usually is caused by toggling the key too slowly.) +  - Beginning with the ignition on but the engine not running, the minimum sequence is:  turn the key off (first time) for 1/2 second, on for 1/2 second, off (second time) for 1/2 second, on for 1/2 second, off (third time) for 1/2 second, then on and leave on. (The speed of the off-on should be about like a clock going tick-tock or a bit faster. ​ Failure to reset usually is caused by toggling the key too slowly.) 
- - If you initiate logging prior to performing the reset sequence, the logging will halt (the seconds counter will stop updating) the instant the reset happens.+  - If you initiate logging prior to performing the reset sequence, the logging will halt (the seconds counter will stop updating) the instant the reset happens.
  
v3hardreset.txt · Last modified: 2009/07/24 14:56 by dmertz