v3hardreset
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
v3hardreset [2009/05/26 16:11] dmertz |
v3hardreset [2009/07/24 14:56] dmertz |
||
|---|---|---|---|
| Line 16: | Line 16: | ||
| - Beginning with the ignition on but the engine not running, the minimum sequence is: turn the key off (first time) for 1/2 second, on for 1/2 second, off (second time) for 1/2 second, on for 1/2 second, off (third time) for 1/2 second, then on and leave on. (The speed of the off-on should be about like a clock going tick-tock or a bit faster. Failure to reset usually is caused by toggling the key too slowly.) | - Beginning with the ignition on but the engine not running, the minimum sequence is: turn the key off (first time) for 1/2 second, on for 1/2 second, off (second time) for 1/2 second, on for 1/2 second, off (third time) for 1/2 second, then on and leave on. (The speed of the off-on should be about like a clock going tick-tock or a bit faster. Failure to reset usually is caused by toggling the key too slowly.) | ||
| - If you initiate logging prior to performing the reset sequence, the logging will halt (the seconds counter will stop updating) the instant the reset happens. | - If you initiate logging prior to performing the reset sequence, the logging will halt (the seconds counter will stop updating) the instant the reset happens. | ||
| + | - With firmware v3.18.205 or earlier in the ECU, to be sure that the default settings are properly saved after executing the hard-boot procedure, use the PC app to modify any configuration value and Save to ECU before shutting off the ignition. | ||
v3hardreset.txt ยท Last modified: 2024/03/15 11:16 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
