On this page, we cover the typical installation configurations for an electronic boost control solenoid. There are other ways and other solenoids, but we're going to focus specifically on what we've actually tested to work. This includes the Ingersoll-Rand 3-port solenoid and the factory boost control solenoid.

The first thing you'll need to do is to wire the sensor into your harness.

To do that, locate the factory BCS connector under your hood. It will be located near the passenger side headlight area and will look like the connector to the right.

If you are installing a stock boost control solenoid using the stock restrictor configuration, then this is pretty easy…just plug it into the stock harness.

If you are installing a different aftermarket sensor, then you'll need to either locate a mating connector for the stock harness