This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
If you're looking to run a set of stock EVO8 injectors or an EVO8 MAF with your V3 ECMLink or V3Lite setup, this page contains the information you'll need to adjust the ECMLink configuration to match. All of this data was pulled directly from the EVO8 ECU, so it's dead on accurate. I run these files in my own EVO8 (using various DSM and EVO1-3 ECUs) and the settings are 100% accurate with fuel trims hoovering around 0%.
If you're running EVO8 injectors with your ECMLink-equipped ECU, here are some numbers you can use to get the ECU configured to match identically with the EVO8 ECU itself.
In "ECU config" on the "Fuel" tab, set Global fuel to -17.6% and then set deadtime to 0 usecs. This assume you're running stock fuel pressure for your ECU. If you're running a 1G DSM ECU, that means 37 psi. If you're running anything other ECU, that means 42.6 psi. If you're running a non-stock fuel pressure, you'll need to adjust the global fuel scale accordingly.
V3Lite note: V3Lite does not provide a "Fuel" tab. Instead, you'll go into the InjectorComp tab in direct access and enter fuel flow rate instead. For EVO8 injectors, you'll want to use 540 cc/min. Yes, I know, everyone says these are 560 injectors. The EVO8 ECU disagrees. It says they are 546 cc/min and when adjusted for stock fuel pressure (42.6), these flow 540 cc/min. If you have a 1G and are running 37psi base, then you'll use 546 * sqrt(37/43.5) = 504 cc/min instead.
In the InjBatteryAdj table in direct access, set the table like so:
For the full V3 package, you can simply select "EVO8/3G MAF" as your Base MAF type on the MAFComp tab and zero out any MAFComp adjustments you had in place previously. That's all there is to do on the full V3 package.
V3Lite note: You need to replace each of the underlying base MAF tables yourself because V3Lite does not include MAFComp functionality. This isn't hard to do, though. Just load the following file into the ECMLink application and hit "Copy all to ECU". That's about it.
EVO8-stock-MAF-v3lite.eda
New Direct Access tables that drop into place in ECMLink to provide exact copies of the EVO8 tables.