evo8v3settings
This is an old revision of the document!
Table of Contents
EVO8 V3 and V3Lite Settings
If you're looking to run a set of stock EVO8 injectors or an EVO8 MAF with your V3 ECMLink or V3Lite setup, this page contains the information you'll need to adjust the ECMLink configuration.
EVO8 injectors
If you're running EVO8 injectors with your ECMLink-equipped ECU, here are some numbers you can use to get the ECU configured to match identically with the EVO8 ECU itself.
Fuel Adjustments Table
In “ECU config” on the “Fuel” tab, set Global fuel to -17.6% and deadtime to 0 usecs.
InjBatteryAdj
In the InjBatteryAdj table in direct access, set the table like so:
| Volts | usecs |
|---|---|
| 7 | 2235 |
| 9 | 1380 |
| 12 | 900 |
| 14 | 570 |
| 16 | 345 |
| 19 | 195 |
evo8v3settings.1259076580.txt.gz · Last modified: 2009/11/24 10:29 by twdorris
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
