This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
injbatadj [2009/09/18 02:12] twdorris |
injbatadj [2024/03/15 11:16] (current) |
||
---|---|---|---|
Line 4: | Line 4: | ||
This page provides a simple explanation of how to "see" the effect of this table in your datalogs. | This page provides a simple explanation of how to "see" the effect of this table in your datalogs. | ||
+ | |||
+ | |||
Line 15: | Line 17: | ||
The picture below shows a clip of a datalog where the power window switch was used to raise the windows until the windows were closed and then the switch was held a few seconds longer to produce a load on the alternator. As you can see, this dropped battery voltage and the mixture went lean as a result. | The picture below shows a clip of a datalog where the power window switch was used to raise the windows until the windows were closed and then the switch was held a few seconds longer to produce a load on the alternator. As you can see, this dropped battery voltage and the mixture went lean as a result. | ||
- | {{http://www.ecmtuning.com/images/forums/injbatadj-1.gif }} | + | {{https://www.ecmtuning.com/images/forums/injbatadj-1.gif }} |
The following is the InjBatAdj table that was used. The injectors in this case were FIC 850s running at 43.5psi base fuel pressure. | The following is the InjBatAdj table that was used. The injectors in this case were FIC 850s running at 43.5psi base fuel pressure. | ||
Line 28: | Line 30: | ||
| 19| 825| | | 19| 825| | ||
- | **NOTE:** That list is total deadtime. It would assume use of "0" in the ECMLink deadtime offset field on the fuel tab. | + | **NOTE:** That list is total deadtime. To use with ECMLink, set the deadtime offset field on the Fuel tab to zero. |
Line 36: | Line 39: | ||
Based on the data from above, the 12-volt entry was increased by 150usecs. The 9-volt entry was also increased just to provide a "smoother" transition to the 7-volt entry. The result is shown in the image below. | Based on the data from above, the 12-volt entry was increased by 150usecs. The 9-volt entry was also increased just to provide a "smoother" transition to the 7-volt entry. The result is shown in the image below. | ||
- | {{http://www.ecmtuning.com/images/forums/injbatadj-2.gif }} | + | {{https://www.ecmtuning.com/images/forums/injbatadj-2.gif }} |
The following is the table that was used. | The following is the table that was used. | ||
Line 48: | Line 51: | ||
| 16| 930| | | 16| 930| | ||
| 19| 825| | | 19| 825| | ||
+ | **NOTE:** That list is total deadtime. To use with ECMLink, set the deadtime offset field on the Fuel tab to zero. | ||