User Tools

Site Tools


sdoptions_iat

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
sdoptions_iat [2016/07/05 14:42]
twdorris [SD Options - With IAT sensor]
sdoptions_iat [2016/07/31 08:12]
twdorris [GM-style MAP with IAT]
Line 11: Line 11:
  
 ===== GM-style MAP with IAT ===== ===== GM-style MAP with IAT =====
 +
 +
 +==== SD Cable ====
  
  
 If you're running a GM-style MAP and the IAT sensor, then the most obvious choice for connecting these to your car's wiring harness is to use our [[http://​www.ecmtuning.com/​product_info.php?​cPath=26&​products_id=52|SD Cable]]. That will plug directly into your car's MAF connector on one end and then into the MAP and IAT sensor on the other. If you're running a GM-style MAP and the IAT sensor, then the most obvious choice for connecting these to your car's wiring harness is to use our [[http://​www.ecmtuning.com/​product_info.php?​cPath=26&​products_id=52|SD Cable]]. That will plug directly into your car's MAF connector on one end and then into the MAP and IAT sensor on the other.
 +
 +
 +==== No SD Cable ====
  
  
Line 27: Line 33:
  
  
-The IAT sensor will need to either be wired directly into the wiring harness or you can consider using our [[http://​www.ecmtuning.com/​product_info.php?​cPath=26&​products_id=52|SD Cable]] if you want. If you use our SD cable, then you'll just leave the MAP connector unused since your Mitsubishi-style MAP will plug into the factory MDP wiring instead. If you decide to hardwire the IAT sensor, then you'll want one side going to sensor ground and the other side going to the ECU's IAT input. Pin out information can be found on our [[:​ecuwiringinformation|ECU wiring information]] page.+<font 12.8px/​arial;;#​000000;;#​ffffff>​The</​font> ​IAT<font 12.8px/​arial;;#​000000;;#​ffffff>​sensor will need to either be wired directly into the wiring harness or you can consider using our</​font> ​[[http://​www.ecmtuning.com/​product_info.php?​cPath=26&​products_id=52|SD Cable]]<font 12.8px/​arial;;#​000000;;#​ffffff>​if you want.</​font>​  
 + 
 + 
 +==== SD Cable ==== 
 + 
 + 
 +If you use our SD cable, then you'll just leave the MAP connector ​on the SD cable unused since your Mitsubishi-style MAP will plug into the factory MDP wiring instead. ​ You can consider cutting the MAP connector off the SD cable and using the wires to log some other sensor if you want.   
 + 
 + 
 +==== No SD Cable ==== 
 + 
 + 
 +If you decide to hardwire the IAT sensor, then you'll want one side going to sensor ground and the other side going to the ECU's IAT input. Pin out information can be found on our [[:​ecuwiringinformation|ECU wiring information]] page.
  
sdoptions_iat.txt · Last modified: 2024/03/15 11:16 (external edit)