This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
teflontape [2010/08/23 16:52] twdorris |
teflontape [2010/08/23 16:59] twdorris |
||
---|---|---|---|
Line 1: | Line 1: | ||
Thanks to the guys over at [[http://www.airridetalk.com/tutorials/tutorials/teflon-wrapping-technique.html|airridetalk.com]] for this handy little "how to" describing the proper use of teflon tape on pipe threads. | Thanks to the guys over at [[http://www.airridetalk.com/tutorials/tutorials/teflon-wrapping-technique.html|airridetalk.com]] for this handy little "how to" describing the proper use of teflon tape on pipe threads. | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
Line 18: | Line 25: | ||
Here we have a roll of Teflon tape and a fitting with 3/8" NPT threads. Your hands and the fitting should be clean of any debris or dirt. | Here we have a roll of Teflon tape and a fitting with 3/8" NPT threads. Your hands and the fitting should be clean of any debris or dirt. | ||
- | {{teflon1.jpg }} | + | {{ teflon1.jpg }} |
- | // | ||
Begin by holding the Teflon tape roll in your left hand and the fitting in your right. | Begin by holding the Teflon tape roll in your left hand and the fitting in your right. | ||
- | {{teflon2.jpg }} | + | |
+ | {{ teflon2.jpg }} | ||
Place the tape on top of the threads and hold the tape with down if your index finger and roll the fitting in a clockwise direction. | Place the tape on top of the threads and hold the tape with down if your index finger and roll the fitting in a clockwise direction. | ||
- | {{teflon3.jpg }} | + | |
+ | {{ teflon3.jpg }} | ||
+ | |||
Wrap the Teflon tape 3 times around the fitting, then hold down on the threads with your thumb and pull on the tape roll to 'cut' the tape. You now have a properly wrapped fitting ready for use that will not leak when installed properly. To properly install, install the fitting hand tight, then give it up to two turns with a wrench. If it wants to stop before two turns, then DO NOT force the fitting. You can damage the threads or destroy the Teflon seal. | Wrap the Teflon tape 3 times around the fitting, then hold down on the threads with your thumb and pull on the tape roll to 'cut' the tape. You now have a properly wrapped fitting ready for use that will not leak when installed properly. To properly install, install the fitting hand tight, then give it up to two turns with a wrench. If it wants to stop before two turns, then DO NOT force the fitting. You can damage the threads or destroy the Teflon seal. | ||
- | {{teflon4.jpg }} | + | {{ teflon4.jpg }} |